Kemper KHS VAV-PLUS Instructions D'installation Et D'utilisation page 13

Safety instructions for installation and maintenance
Installation and use
Read the manual carefully and follow the
instructions before installation!
Always pass on this manual to the current
device operating organisation and retain the
manual for later reference!
Warning! The product must only be used in
closed, frost free and dry rooms.
Warning! Installation and maintenance
must be carried out by qualified plumbers.
Only specialists with electrical system quali-
fications are permitted to carry out electrical
installation!
Warning! Priority must be given to the nati-
onal standards and provisions on Health and
Safety Regulations.
Warning information
Please read and follow the warning infor-
mation in this instruction. Disregard of the
warning information may lead to injury or
material damage!
Labelling of important warning information:
Danger! Electricity!
Indicates hazards that might
result in severe or fatal injury.
Warning! Highlights risks that
may result in injury, material
damage or contamination of
drinking water.
© www.kemper-olpe.de – 01.2021 / K410068601001-00 – 13 / 52
Note! Indicates hazards that
may lead to damages to the
system or malfunctions.
Important advice to the operator
If power fails, the valve automatically closes
(currentless closing).
The valve is controlled by:
24 V DC Figure 686 01
- Building management system
- LOGIC system control (without shut-off
function)
230 V AC Figure 686 05
- KHS Timer
- KHS Mini system control MASTER 2.0 I 2.1
- Leak Protection System
Maintenance
According to DIN EN 806 Part 5, the operator
has to make an annual inspection.
Disposal
Local regulations on waste re-
cycling and disposal must be
followed. The product must not
be disposed of with household
waste but must rather be dis-
posed of appropriately.