Ribimex Ribiland PRMPP087 Traduction Des Instructions D'origine page 34

The breakage and short
circuit of the coil
Lack of water in the pump Supply water.
Looseness of the joint of
the suction hose
Inferior buckles at the
joint of the suction hose
No suction
Cracking and damage of
the suction
Bent drainpipe, the valve
is locked.
Blockage of the suction
filter screen
Higher place than that of
the water source pump
Too far away or too high
from the water supply
Blockage inside the pump
Wear-out of the turbine
Small amount
Too low speed of the
of delivery
engine
Low output power of the
engine
Looseness of the
assembled screw bolt
Water is
Damage or cracking of
leaking out
the buckle
from the pump.
Wear-out or damage of
the mechanical seal
Replace. (Competent servicing dealer)
Don't let air in when installing.
Replace a quality-proven one. (Competent servicing
dealer)
Replace a quality-proven one. (Competent servicing
dealer)
Straighten the bent part and turn on the valve.
Clean the suction filter screen.
Get the pump close to the water source.
Get the pump close to the water supply spot, as close
as possible.
Disassemble and repair the pump. (Competent
servicing dealer)
Replace the turbine. (Competent servicing dealer)
Throttle up.
Inferior fuel--replace and check.
Check whether the air filter is blocked--clean.
Check whether the fuel filter is blocked –clean.
Adjust and repair the carburetor. (Competent
servicing dealer)
Disassemble and repair the engine. (Competent
servicing dealer)
Increase the torsional force.
Replace the buckle. (Competent servicing dealer)
Replace the mechanical seal. (Competent servicing
dealer)
- 31 -