The Heat Setting; Automatic Heat Up - Leonard LAS6060F Notice D'utilisation

Masquer les pouces Voir aussi pour LAS6060F:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

8 Leonard
acoustic signal sounds and the hob
deactivates. Remove the object or
clean the control panel.
• you do not deactivate a cooking zone
or change the heat setting. After some
time
comes on and the hob
deactivates.
The relation between the heat setting
and the time after which the hob
deactivates:
Heat setting
, 1 - 2
3 - 4
5
6 - 9

The heat setting

Touch
to increase the heat setting.
Touch
to decrease the heat setting.
Touch
and
at the same time to
deactivate the cooking zone.
Activating and deactivating the
outer rings
You can adjust the surface you cook to
the dimension of the cookware.
Use sensor field:
To activate the outer ring: touch the
sensor field. The indicator comes on.
To deactivate the outer ring: touch the
sensor field until the indicator goes out.

Automatic Heat Up

If you activate this function you can get a
necessary heat setting in a shorter time.
The function sets the highest heat setting
for some time and then decreases to the
correct heat setting.
To activate the function the
cooking zone must be cold.
The hob deacti‐
vates after
6 hours
5 hours
4 hours
1.5 hour
To activate the function for a cooking
zone: touch
until the correct heat
setting comes on. After 3 seconds
comes on.
To deactivate the function: touch
Timer
Count Down Timer
You can use this function to set how long
the cooking zone should operate for a
single cooking session.
First set the heat setting for the cooking
zone then set the function.
To set the cooking zone: touch
and again until the indicator of a
necessary cooking zone comes on.
To activate the function or change the
time: touch
or
time (00 - 99 minutes). When the indicator
of the cooking zone starts to flash slowly
the time counts down.
To see the remaining time: set the
cooking zone with
cooking zone starts to flash quickly. The
display shows the remaining time.
To deactivate the function: set the
cooking zone with
remaining time counts back to 00. The
indicator of the cooking zone goes out.
When the time comes to an
end, the sound operates and
00 flashes. The cooking zone
deactivates.
To stop the sound: touch
Minute Minder
You can use this function as a Minute
Minder when the hob is activated and the
cooking zones do not operate. The heat
setting display shows
To activate the function: touch
Touch
or
of the timer to set the time.
.
again
of the timer to set the
. The indicator of the
and touch
. The
.
.
.

Publicité

Table des Matières
loading

Table des Matières