Junker JD36AL51 Manuel D'utilisation Et Notice D'installation page 26

en Installation instructions
Create the cut-out for the pipe connection.
4.
If the cabinet base is in place, remove it.
5.
Remove any shavings.
6.
7. Use the enclosed template to mark the fastening
points on the inside of the cabinet and use a
bradawl to make indentations where the holes are
to be.
Screw in the four enclosed screws for the angle
8.
bracket up to 5 mm.
Preparing the appliance
Insert the holders for the wall edging strip on the
1.
outside rear of the appliance into the cut-outs and
fold them in to the centre of the unit.
26
Use the screws provided to secure the handle strip
2.
to the filter pull-out.
Connect the enclosed power cord to the appliance
3.
and secure the stain relief.
Screw the two angle brackets to the appliance. Note
4.
the position of the screws. Screw in the screws until
8 mm of the threaded section is still protruding.
Installing the appliance
Use the angle brackets to hang the appliance on
1.
the screws, align it and tighten it.