Roberts 10-60 Manuel D'utilisation page 5

MAINTENANCE
Changing the Blade
Use Roberts #10-460 9" Replacement
Blade. Use the provided Allen
wrench to remove the five screws,
then hold the blade at each end and
carefully move the blade out of
blade holder.
Note: The flat side of the blade
should face the table.
Warning: Do not put your fingers
against the sharp edge of the
blade at any time.
Carry
Hook the chain to the ring on the
handle and carry the cutter as
shown.
Warning: Do not put your fingers
against the sharp edge of the
blade at any time.
-4-