Publicité
Les langues disponibles
Les langues disponibles
CUTTING
Cutting Preparation
Place the angle attachment into the
cutter head and push it as much as
you can to the bottom. Change the
cutting angle from 90° to 45° as
needed.
Warning: Do not put your fingers
against the sharp edge of the
blade at any time.
Straight Cut (90° angle)
Insert material between the cutting
blade and the base as shown and
hold the material with the flooring
holding bar , then push handle down
to complete a cut.
Warning: Maintain control of the
handle. Do not allow handle to
slam back after making a cut.
Angle Cut (45° angle)
Install the 0-45° Attachment as
shown. Position the cutting angle to
the 45° angle.
Warning: Maintain control of the
handle. Do not allow handle to
slam back after making a cut.
-3-
Publicité
