Safety Instructions; Remedy - ELV Electronik ETH comfort Mode D'emploi

eQ-3 Entwicklung GmbH hereby declares that this device
complies with the essential requirements and other rele-
vant regulations of Directive 1999/5/EC. You can find the
full declaration of conformity at www.eQ-3.com.

7. Safety instructions

This device is not a toy; do not allow children to play with
it. Do not leave packaging material lying around, as it can
be dangerous in the hands of a child.
Do not open the device: it does not contain any
components that need to be serviced by the user. In the
event of an error, please return the device to our service
department.

8. Remedy

If no data is being sent to the radio energy-saving control-
ler, you can check the following:
Range:
Make sure that the receivers are located in the wireless
range of the USB programming stick.
Receive mode:
The receiving devices must be set to teach-in mode
during transmission.
PC software:
Data cannot be sent unless the corresponding PC software
has been installed and activated. The USB stick must also
be plugged into the PC's USB port; the operating system
will detect the USB programming stick automatically.
14