Pc Software; Radio Transmission Of Programming Settings - ELV Electronik ETH comfort Mode D'emploi

The PC software for the USB programming stick can be
downloaded from www.elv.de.
To start the download directly, type the following URL into
the address line of your browser:
www.ethcomfort.elv.de
Follow the on-screen instructions when downloading the

PC software.

4. Radio transmission of programming settings

So that the USB programming stick can send data to sys-
tem components such as radio energy-saving control-
lers, these components must first of all be set to teach-
in mode.
• The USB programming stick must be plugged into the
PC's USB port.
The PC software must be running on the PC and
•
programming must be complete.
For transmission, the receiver must be set to teach-in
•
mode. For more information on this, refer to the opera-
ting manual for the relevant device.
• The USB programming stick can now send data to
the devices that are ready to receive. To start the
transmission process, activate the transmission
function in the PC software.
The USB programming stick does not remain permanently
taught–in on the devices to be programmed.
12
3. PC software