System Requirements; Information About Radio Operation - ELV Electronik ETH comfort Mode D'emploi

If the USB programming stick is being used to send
a weekly programme, all devices that are ready to
receive will receive the programme accordingly. An
unlimited number of receivers can be programmed.
When being put into operation for the first time, a
radio energy-saving controller can be switched to
teach-in mode immediately after data entry (please see
the corresponding operating manual for detailed
instructions). If a wireless signal is received from the USB
programming stick during the teach-in period, the radio
energy-saving controller will change over to continuous
reception and PCC (PC configuration) will appear on the
display. You can exit PCC mode again by pressing the OK
button.
Windows
•
®
• USB connection
6. General information about radio operation
Radio transmission is performed on a non-exclusive trans-
mission path, which means that there is a possibility of
interference occurring. Interference can also be caused
by switching operations, electrical motors or defective
electrical devices.
The range of transmission within buildings can differ grea-
tly from that available in the open air. Besides the transmit-
ting power and the reception characteristics of the recei-
ver, environmental factors such as humidity in the vicinity
have an important role to play, as do on-site structural/
screening conditions.

5. System requirements

XP, Windows Vista™
13