Victaulic I-900 Instructions De Montage page 4

I-900
Piping systems must always be depressurized and drained before attempting disassembly and removal of any
Victaulic piping products.
Failure to do so could result in serious personal injury, property damage, joint leakage or joint separation.
• Victaulic products for HDPE pipe must be installed using non-soap based lubricants. Corn oil, soybean oil, glycerin,
silicone oil or silicone release agent must be used. DO NOT USE Victaulic lubricant, hydrocarbon based oils,
greases or soap based solutions.
• Use of HDPE couplings on other pipe materials or with soap based lubricants may result in property damage or
serious personal injury.
GASKET SELECTION MUST ALWAYS BE SPECIFIED ON YOUR ORDER
TEMP.
GRADE RANGE
–30°F to +230°F
E
(–34°C to +110°C)
–20°F to +180°F
T
(–29°C to +82°C)
ALWAYS CHECK GASKET SUPPLIED TO BE CERTAIN IT IS SUITED FOR THE SERVICE INTENDED.
REFER TO VICTAULIC GASKET SELECTION GUIDE (05.01).
ALWAYS LUBRICATE GASKET FOR PROPER COUPLING ASSEMBLY.
*Services listed are General Service Recommendations only. It should be noted that there are
services for which these gaskets are not recommended. Reference should always be made to
the latest Victaulic Gasket Selection Guide (05.01) for specific gasket service recommenda-
tions and for a listing of services which are not recommended.
Gasket compatibility only. Plastic pipes are designed to have a specific rating at a temperature
of +73°F (+23°C). Any variation of the temperature will have an effect on the static pressure
rating of the pipe, thus, as the temperature increases, the pressure rating will decrease. Con-
tact the pipe manufacturer for temperature and pressure limitations of their pipe.
4
COLOR
COMPOUND CODE
No Color
or
EPDM
Green
Stripe
Orange
Nitrile
Stripe
*GENERAL SERVICE RECOMMENDATIONS
Recommended for hot water service within the specified
temperature range plus a variety of dilute acids, oil-free
air and many chemical services. Not recommended for
petroleum services. Not recommended for steam ser-
vices.
Recommended for petroleum products, air with oil vapors,
vegetable and mineral oils within the specified tempera-
ture range. Not recommended for hot water services over
+150°F (+66°C) steam, or for hot dry air over +140°F
(+60°C).