Battery Replacement; Base Station; Exterior Unit - Conrad Electronic KW-9015 Notice D'emploi

12. Battery Replacement

a) Base station
Proceed as described in chapter 9. a).

In the case of a change of battery all data of the base station get lost:
Normally the base station should display the measuring data of the exterior unit after some
minutes (switch to outdoor temperature display with the "SEARCH IN/OUT TEMP" (D) button).
If this is not the case, open the battery compartment of the exterior unit and press the "TX"
button that can be found between the two batteries. Use, eg a toothpick to actuate the button.
b) Exterior unit
Proceed as described in chapter 9. b).
Directly after inserting the batteries, the exterior unit will send a data packet, this is why the
base station should instantly recognize the exterior unit (if applicable, switch over to the display
of the outdoor temperature with the "SEARCH IN/OUT TEMP" (D) button.
If this is not the case, press the "TX" button that can be found between the two batteries in the
battery compartment of the exterior unit. Use, eg a toothpick to actuate the button.
The base station will emit a short tone signal when the first data packet is received.
56