Getting Started - Conrad Electronic KW-9015 Notice D'emploi

9. Getting Started

a) Base station:
Insert batteries, carrying out basic settings
Please proceed in the following sequence:
• To make opening the battery compartment easier, the base stand can be taken off. Do not
simply pull it out directly toward the bottom (don't excert any force, don't bend it, simply slide
it out toward the bottom!).
• Now insert 3 batteries type mignon/AA into the battery compartment on the back of the base
station. Pay attention to correct polarity (observe plus/+ and minus/-, see imprint in battery
compartment and on batteries).

As already described in chapter 6, you can also use rechargeable batteries.
Close the battery compartment and put the base stand back on.
• All display elements will appear briefly and a tone signal can be heard.
"24h" will flash on the display.

If you don't carry out any settings within about 10 seconds, "0:00" will appear
on the display. The setting process can be reactivating by pressing the "RAIN
SETTING" (A) button for a longer period of time (flashing "24h" will reappear).
• With the " SINCE" (B) and/or " HISTORY" (C) button you set the time display mode (12
or 24 hour mode).
• Confirm the setting by briefly pressing the "RAIN SETTING" (A) button.
• "TIME" appears on the display and the hours start to flash. They can be set with the
" SINCE" (B) and/or " HISTORY" (C) buttons.

Hold the respective button down for a longer period of time, to activate the fast
adjustment.
If the clock is to be operated in the 12 hour mode, "AM" for morning and "PM"
for afternoon will appear.
41