Battery Safety And Disposal; Getting Started - LENCO CR-430DAB+ Mode D'emploi

1. BATTERY INSTALLATION AND USE
To use the appliance with batteries ensure that the power cord is not connected to the mains
and install the batteries into the battery compartment.
1.1 Lift off the battery compartment cover from the underside of the
radio.
1.2 Insert 4x AA 1.5V alkaline batteries (not included) in accordance
with the diagram in the battery compartment. Take care to observe
the correct polarity (+/‐).
1.3 Refit the battery compartment cover.
1.4 Do not expose the batteries or the installed batteries to excessive heat (e.g. fire, sunshine
or position close to radiators etc.).
Notes:
All DAB radio's use more power during use than 'traditional' radios and so will run batteries
down within a few hours. Therefore use of mains power (or rechargeable batteries) is
recommended for extended listening.
Always switch off using the on/off at rear when not in use. Standby mode continues to use
power and (if in battery mode) will flatten the batteries within a couple of days.
BATTERY SAFETY AND DISPOSAL
CAUTION‐Danger of explosion if batteries are incorrectly fitted/replaced.
Only use 'AA' 1.5V batteries in this appliance.
Be sure to insert batteries correctly taking care to observe the correct polarity (+ and ‐).
Use only batteries of the same or equivalent type as recommended.
Batteries should be replaced by an adult.
Do not recharge non‐rechargeable batteries.
Remove rechargeable batteries from appliance before recharging.
Never mix old and new batteries (replace all batteries at the same time).
Never try to dismantle batteries.
Always remove exhausted or dead batteries from the product.
Remove batteries from the product before extended storage.
Dispose of batteries responsibly at local authority household waste recycling facility.
DO NOT dispose of batteries in a fire as the batteries may explode.
2. GETTING STARTED
2.1 If using mains power, insert the adaptor cord into the power socket at the rear of the radio.
Plug the adaptor into the mains supply socket.
2.2 If using the radio with batteries ensure that the power cord is not inserted into the back of
the appliance and install the batteries into the battery compartment.
2.3 Fully extend the telescopic antenna.
2.4 Move the on/off switch at the rear of the radio to the 'on' position and the display will
illuminate, a welcome message will be displayed briefly (Fig. 1) and then the clock (00:00:00)
will be shown.
2.5 Press the Standby ( ) button to turn the radio on and start to tune in.
2.6 DAB mode will automatically be selected and the radio will perform an autotune full scan
(Fig. 2). The display will then show 'searching', together with a slide bar (Fig. 3) that
indicates the progress of the scan and the number of stations found so far.
Fig. 1
5