Sleep Timer; Care And Maintenance - LENCO CRW-1 Mode D'emploi

Eng

Sleep Timer

The Sleep timer allows you to set the unit to automatically turn off the Radio
after a selected sleep time.
- To activate the sleep timer and select the sleep time, press the SLEEP
button repeatedly. The sleep time available for choosing are:10, 30, 60 and
90 minutes. The display will show the indicator "Sleep".
- To switch off the sleep timer, press SLEEP button repeatedly until the
"SLEEP" indicator disappears.
- To switch off the unit before the selected time, press the POWER button
once.
Rainbow Light Dome
The unit has a special feature that its dome with rainbow light.
you may activate the rainbow light by sliding the RAINBOW LIGHT switch to
DIM or LIGHT position.
10

Care and Maintenance

• Do not subject the unit to excessive force, shock, dust or extreme temperature.
• Do not tamper with the unit's internal components.
• Clean your unit with a damp (never wet) cloth. Solvent or detergent should
never be used.
• Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
• Keep your unit away from heating appliances and sources of electrical noise
such as fluorescent lamps or motors.
Resetting the Unit
If the unit is subjected to a severe power surge or electric shock, it is possible
that the internal microcontroller may "lock up" and the unit will not respond to
any commands from the top panel controls.
1. In this event, unplug and then reconnect the AC power plug into the wall
outlet.
2. Use a straightened paper clip, toothpick, or similar blunt object to press the
RESET button located at bottom of the main unit (see figure below). The
reset operation clears the system memory and all of your previous settings
will be erased.
Caution: DO NOT use a sharp, pointed object to press the RESET button.
It may damage the reset switch inside the unit.
RESET button
11
Eng