Power Supply; Battery Backup; Setting The Clock Time - LENCO CR-205 Mode D'emploi

1. Power On/Off & Alarm Off
2. Volume Down & Alarm-1
3. Volume Up & Alarm-2
4. Tuning Down & Hour
5. Tuning Up & Minute
6. Preset & Clock Set
7. Snooze & Sleep
8. PM Indicator
9. Buzzer Alarm-1 Indicator
10. Radio Alarm-1 Indicator
11. LED Clock & Radio Frequency Display
12. Sleep Indicator
13. Buzzer Alarm-2 Indicator
14. Radio Alarm-2 Indicator
15. Speaker
16. FM Antenna
17. Backup Battery Compartment
18. Power Cord AC230V~50Hz

POWER SUPPLY

1. To power the device, plug the AC power cord into the AC power input on the rear of
the unit and a standard power outlet
2. To the standby mode(*LED display flashing) once collecting power

BATTERY BACKUP

Insert 2x AAA/LR6 batteries for time backup in case of a mains power failure.
Note: the clock will not work on batteries only. The batteries are only for time backup.
*There is NO flashing display after power disconnect. Time and Alarm settings are
reset when backup battery is empty or not installed.

SETTING THE CLOCK TIME

1. In standby mode, press and hold the Preset & Clock Set button
2. The hours will blink. Press Tuning Down & Hour Button to set the current hour.
3. Press the Tuning Up & Minute button to set the current minute.
7