Bartscher 200270 Mode D'emploi page 29

Indication of required value
•
press
•
press
Change of required value (required temperature)
•
to change the required value, press
•
the required value will be displayed and
•
with use of
until the required value is displayed;
•
new value should be confirmed by pressing
will be automatically stored.
NOTE!
If you wish to change other settings or parameters, instructions on how to do so
can be found in the information included concerning temperature control, or such
changes can be performed by qualified service personnel.
Defrosting
Automatic defrosting
The device automatically defrosts 3 times per 24 hours. The internal clock is activated the
first time the device is turned on.
If the automatic defrosting is to be performed in other periods, press
5 seconds. The digital display shows
defrost, then the next defrost will begin in 6 hours
Manual defrosting
Manual defrost can be activated at any time in addition to automatic defrost: press
button for longer than 5 seconds. The manual defrosting will begin. The digital display
shows .
NOTE!
Water created during defrosting is drained through the pipe to the bottom of the
device where it evaporates.
- 28 -
button to display the required value;
again or wait 5 seconds to return to the previous indication.
or buttons it is possible to decrease or increase the value
button for longer than 2 seconds
or diode will flash on the display;
button or wait 10 seconds and it
. The device will immediately begin automatic
for longer than