Yakima CARGO BOX LIGHT Mode D'emploi

VAKIMÆcARG0Box
REQUIRED TOOL:
CROSS-TIP SCREW DRIVER
USE ONLY SCREWS
PROVIDED. SCREWS
LONGERTHAN 1/2" (12 MM)
CAN DAMAGE THE BOX.
Caution: Do not look directly into the switched-on light.
O
DISCONNECT LIGHT
FROM BASE
Push release tab to allow lightto
slide out from base.
INSTALL BATTERIES
• Removebattery cover using your thumb.
• Insert three AAA batteries and replace cover.
1033373A-l/2
LIGHT
Screws
Light
Light Base
Release Tab
Slide red switch to turn
light on and off.
DO not 100k directly into
the switched-on light.
3
SKYBOX ONLY: INSTALL LIGHT
You must be able to reach your light after it is installed.
• Choose one of the six recessed sections in the SkyBox lid frame
• Use the pre drilled holes to install the lamp base with screws provided
• Tlghten
Use only screws provided; screws longer than 1/2"(12mm) can damage the box.
OTHER BOXES:
INSTALL LIGHT WITH ATTACHED
You must be able to reach your light after it is installed
• Selecta flat surface for the light
• peel backing from pad
• press the light base into position
BULB IS GUARANTEED FOR 5,000 HOURS.
This product is covered by
YAKIMA's "Love It Till You Leave
Limited Lifetime Warranty
To obtain a copy of this warranty,
go online to www.yakima.com
or email usat yakwarranty@yakima.com
or call (888) 925-4621
KEEP THESE INSTRUCTIONS!
USING SCREWS
ADHESIVE PAD
Do not use screws
install the light unless
installing into Yakima
SkyBox models.
TECHNICAL ASSISTANCE
REPLACEMENT PARTS
CONTACT YOUR DEALER
It"
OR CALL (888)925-4621
MONDAY THROUGH
7:00 AM TO 5:00 PM, PST
Part #1033373 Rev.A
to
OR
FRIDAY