Hazet-Werk 5000 CT Série Mode D'emploi page 30

GB
Please make sure that both torque wrench parts
are firmly attached.
The torque wrench is now ready for use.
The desired torque value may be selected.
(Type 6100 CT)
Disassembly
• Use the disassembly tool 6 to push the locking
bolt 4 back into the bore hole of the head part.
• At the same time, turn the handle part 1 to the
right, so that the handle part bolt 3 may slide out
of the location notch.
Setting the torque on the 6108-1 CT,
6109-2 CT, 6280-1 CT and 6282-1 CT
• Release the adjusting mechanism by retract ing
the locking bush
• With the bush retracted, rotate handle
the required torque
• The preset torque value is locked by releasing
the locking bush.
• The torque wrench is now ready for use.
30
Design and Function
.
and .
USA
to set