Hazet-Werk 5000 CT Série Mode D'emploi page 23

USA
• Any personal injury or material losses caused by
improper use are the sole responsibility of the
operator.
4. Storage
The tool has be stored according
the following conditions:
• Keep tool in a dry and dust-free place.
• Do not expose the tool to liquids or aggressive
substances.
• Do not store the tool outdoors.
• Keep tool out of reach of children.
• Storage temperature: -10°C to +40°C
• Relative air humidity: max. 60%
5. Dangers Emanating from
Before each use, check HAZET tools for full
functional efficiency. Do not use the tool if its func-
tional efficiency cannot be ensured or if damage is
detected. If the tool is used, when it is not in full
working order, you risk severe injuries to persons
and damage to property. Defective tools may
cause severe injury.
In order to avoid injury or damage, it is essential
that the following fundamental safety guidelines
will be observed:
• Always account for tools being used.
• Observe prescribed tightening torque values
(follow manufacturer's instructions).
• Repair work must be carried out exclu sively
by authorized persons.
• Only use the tool within the prescribed places,
and governed under the current regulations
relating to the working environment.
• Stand safely!
• For safety reasons any modification of HAZET
tools is strictly forbidden. Any modification of
this tool will result in immediate exclusion from
warranty and liability.
For Your Safety
the Tool
GB
23