Hazet-Werk 5000 CT Série Mode D'emploi page 28

GB
6. Torque Setting
Setting the torque on the 5000 CT
• Unlock handle
safety lock
• Now use handle
and
• To fix the preset value, turn safety lock
anti-clockwise.
• The torque wrench is now ready for use.
• Please pay attention to the direction of
actuation! By reversing the sliding square
tang the working direction can be changed,
either to the right or to the left. As the torque
wrench is turned for this, the direction of
actuation (or the torque wrench's release
direction, see marker) remains the same.
• Wrench -2 CT is equipped with a reversible ratchet.
Setting the torque on the 5000 CLT
• Unlock handle
safety lock
• To adjust the torque, push handle
and rotate it until the window indicates the
required value.
• The preset value must be within the permit-
ted torque range which is displayed on the
hous ing of the appropriate display.
• One revolution of the handle increases the
torque on the 5121- and the 5122-2 CLT
by 10 Nm, and, in the case of the 5123-
2 CLT, by 20 Nm.
• The set torque is fixed by releasing the
handle.
• In order to prevent accidental maladjustment,
the safety lock
clock wise.
• The torque wrench is now ready for use.
28
Design and Function
.
.
.
by clockwise rotation of
to set the required torque
by clockwise rotation of
should be rotated anti-
USA
forward
-