Sony MHC-EC919iP Mode D'emploi page 15

Notes
 The performance of the system may vary,
depending on the specifications of your
iPod/iPhone.
Operate the iPod/iPhone directly if you
cannot operate the iPod/iPhone normally
using the system.
 When connecting or disconnecting the
iPod/iPhone, brace the system with
one hand and take care not to press the
controls of the iPod/iPhone by mistake.
 Before disconnecting the iPod/iPhone,
pause playback.
 To change the volume level, use VOLUME
+/. The volume level does not change
even if you adjust it on the iPod/iPhone.
 Sony cannot accept responsibility in the
event that data recorded to iPod/iPhone
is lost or damaged when using an iPod/
iPhone with this system.
To use the system as a battery
charger
You can use the system as a battery
charger for an iPod/iPhone when the
system is on.
1
Select the function.
For iPhone 5, iPod touch (5th
generation) or iPod nano (7th
generation)
Press iPod.
For other iPod/iPhone models
Press USB.
2
Connect the iPod/iPhone.
For iPhone 5, iPod touch (5th
generation) or iPod nano (7th
generation)
Connect the iPod/iPhone to the
Lightning connector.
For other iPod/iPhone models
Connect the iPod/iPhone to the
(USB) port, using the USB cable
supplied with the iPod/iPhone.
The charging begins when iPod/
iPhone is connected to the
Lightning connector or the
port. The charge status appears
on the display of iPod/iPhone. For
details, see the user's guide of your
iPod/iPhone.
To stop charging an iPod/iPhone
Disconnect the iPod/iPhone. Turning off
the system also stops charging the iPod/
iPhone.
(USB)
15
GB