Sharp R-7200 Manuel D'installation page 2

ENGLISH
INSTALLATION
1. Visual check after unpacking:
Remove alt packing
Check the unit for any damage, such as a misaligned
door, damaged gaskets around the door or dents inside
the oven cavity or on the door.
please do not operate the oven until it has been checked
by a SHARP AUTHORISED
repaired, if necessary.
2. Exhaust vents are provided
proper cooling and air flow in the cavity.
mendable to have the unit about 1Ocm away from
nearest rear wall to get adequate ventilation. (Fig. 1)
3. The unit should not be installed in any area where heat
and steam are generated, for example, next to a conven-
tional oven unit.
4. Ask for professional advice when the unit is built in.
5. The unit is fitted with a Schuko-plug
is grounded/earthed.
SPECIFICATIONS
AC Line Voltage:
AC Power Required:
Output Power:
Microwave Frequency:
Outside Dimensions:
Cavity Dimensions:
Cooking Uniformity:
Weight:
THIS APPARATUS COMPLIES WITH REQUIREMENTS OF BS 800 AND EEC DIRECTIVE
82/499/EEC.
INSTRUCTIONS
materials from the oven cavity.
If there is any damage,
SERVICE AGENT
at the rear of the unit for
It is recom-
and must be connected to a standard household outlet which
Single phase 220V, 50Hz
1.25 kW
650W (2 litre water load)
2450 MHz
550mm (W) x 358 mm (H) x 389mm (D)
340mm (W) x 217mm (H) x 332mm (D)
Turntable (315 mm tray) System
Approx. 23 kg
and
the
1 Ocm
Fig. 1