BEROTEC MOFESSOR Manuel D'utilisation page 18

B E R O T E C
ATTENTION
ge the switch and does not constitute a warranty claim. We recommend that the plug side of
the cable is routed through the vehicle with the washer and lock nut fitted beforehand. The
cable must be mounted with full strain relief and protected - even at maximum steering angle.
C o m m i s s i o n i n g
The chain should be cleaned before starting up, as otherwise existing dirt and grease
residues will be loosened by the chain oil and thrown off. We recommend our chain clea-
ning set for this purpose.
Once the cabling is complete, the system can be put into operation. Activate the ignition.
The LED on the rain switch lights up for a short moment. This is a self test. From now on
it is possible to select and deselect the rain mode on the switch.
The system must be vented after initial filling. To do this, press and hold the rain switch
for 4 seconds. The red LED starts to flash quickly. This setting opens the dosing valve
permanently. It is now possible to wait until the system has vented itself or overpressure
can be created via the filling opening with an oil-filled syringe. The gold-coloured venting
opening must be closed for this purpose. The air is vented until the oil begins to drip at
the application nozzle. By pressing the rain switch again, the venting is stopped.
ATTENTION
sure that there are no leaks or defects.
18
The cable connection at the rear of the rain
switch must not be bent by force. This will dama-
Before each journey, the entire system must
undergo a visual and functional check to en-
MOFESSOR
English