Bluetooth Connection - LENCO PA-60 Mode D'emploi

BLUETOOTH CONNECTION

- Once the power switch turn to "On", Bluetooth "BT" mode has set as default
- Blue LED indicator will be flash in pairing mode. The RED LED display will show "bt"
- Turn on the Bluetooth function on your device and search for "Lenco PA-60" then
press to connect.
- Connected sound signal will be
heard and the blue led connection
indicator will stop blinking and stay
steady.
- Bluetooth connection is completed.
- Select the music from your Bluetooth
device and start playing.
- Holding the BT DISCONNECT
(BT OFF) key to disconnect paired
device and enter pairing mode.
FM RADIO
- Press the "Source" Button and select to Radio, the FM Radio Frequency will show
on the RED LED display.
- Hold play/pause key to auto search and store.
- Press and hold the TU
station. Short press them to fine tune.
USB PORT
- Press the "Source" Button and select
to USB, USB will show on the RED
LED display.
- Insert the USB stick.
- Select your favorable music by
pressing TU
- Press "REP" once to repeat the
current selected song.
- Press "REP" the 2
songs.
- Press "REP" the 3
- Press "REP" again to turn repeat off.
If unit is playing on Bluetooth mode "BT and LINE", it will automatically
switch to USB mode once insert the USB stick.
Important: The USB port is intended only for data transfer only, Other devices
cannot be used with this USB connection. The use of USB extension cords is not
or TU
or TU .
nd time to repeat all
rd times to random
Bluetooth function
buttons for choosing the next stored available
REP
TU+ /
TU-/
SOURCE /
STANDBY
1
SOURCE
9
EQ
ECHO- ECHO+
MIC -
VOL - VOL +
/
STD-BY BT Low Full
Battery
BT OFF
2
TU+ /
TU-/
MIC +
LIGHT
3
REP