Progress Lighting 5261 Instructions De Montage Et D'installation

RESS '+PRPC
LIGHTING
WARNING - THIS LIGHTING
DO NOT EXCEED WATTAGE
WARNING - If any Special Control Devices are used With this Fixture, Follow the Instructions Carefully to assure full
compliance with N E.C. requirements. If there are any questions, contact a Qualified Electrical Contractor.
CAUTION - All glass ISfragile, use care when handling Glass Shade and lamps
WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and lor
other reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product
CONNECTION
12
OPTIONAL PROGRESS P8618 GROUND STAKE
Estaca Opc•onal P8618 Progress
Reu Facultatif P8618 Progress
FIG. 1
Assembly & Installation
CAUTION: Read instructions
circuit breaker panel before beginning installation.
5261
FIXTURE IS FOR USE WITH MAXIMUM
RATING NOTED ON POWER
TO PROGRESS REMOTE
1 - Slip Fixture Wires (1) down through Nipple (2) and thread Nipple into Stem (3)
2 - Thread Stem (3) firmly down into (Optional)
Fixture Wires (1) out through open Side of stake and make connections
using Wire Connector
stake ISeven with grade (Fig. I)
3 Install lamp (12) 12 volt, 18 watt wedge base (T-5, #921)
4.- Connect Fixture Wire (6) to selected
Assembly (4) provided with fixture. (Fig. 2)
5 - Press 10 Ga cable
Lay the 18 Ga. Wire into slot marked 18 Ga. (Fig. 2) Caution
6.- Assemble the Wire Connector (4) by aligning the Tab (8) of the contact half of the
connector With the Notch (9) In the wired half of the connector.
7.- Compress the two halves by securely tightening
the contacts into the wires. (Fig. 2)
Note: Do not install luminaire within 5 feet of a pool, spa, or fountain
PAGE
carefully and turn electricity off at main
25A, 15V POWER UNITS ONLY
SUPPLY'
TRANSFORMERS
Progress
(4) as shown (Fig. 1). Push stake down into ground until top of
10 or 12 Ga Cable (7) with the Wire Connector
Into slot marked 10 Ga. Press
the Thread Cutting Screw (10), forcing
I Of 4
Instructions
P8618 Ground Stake (5). Slip
to supply Wires
12 Ga cable Into slot marked
Wires must lay flat in the slot.
(Fig. 2)
10
fi*ture
cable
12
FIG. 2
SPEC.NO. 023100
12 Ga.
02-11-09