Progress Lighting 5511 Instructions De Montage Et D'installation

'*PR
CRESS
LIGHTING
WARNING - If any Special Control Devices are used with this Fixture, Follow the Instructions Carefully to assure full
compliance with N.E C. requirements. If there are any questions, contact a Qualified Electrical Contractor.
WARNING - To comply with the National Electric Code and Underwriters Laboratories requirements, the edge of the wall
plate comng In contact With the mounting surface must be sealed With a latex waterproof caulking to prevent water from
entering the outlet box.
CAUTION - All glass ISfragile, use care when handling Glass Shade and lamps
WARNING - This product contains chemcals known to the State of California to cause cancer, birth defects and lor
other reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product
2
7
WHITE SUPPLY WHTE OR IDENTIFIED
WIRE FIXTURE
UL LISTED
WIRENUTS
BLACK SUPPLY PLAIN OR BLACK
WIRE FIXTURE
BARE, OR GREEN BARE, OR GREEN
GROUND WIRE FIXTURE GROUND
FROM SUPPLY WIRE
OR
BARE, OR GREEN
GREEN
SCREW
GROUND WIRE
FROM SUPPLY
1 Fasten Mounting Strap (1) to Outlet Box (2) With Mounting Screws (3) (NOT FURNISHED) from Outlet Box (2)
Thread Nipple (4) and Green Ground Screw (5) into Mounting Strap (1).
2. Connect Fixture Wires (6) to Supply Wires (7) as shown in Wiring Diagram
3. Shp Wall Plate (8) over Nipple (4) and secure In place with Capnut (9)
4. Install Lamp (NOT FURNISHED).
5. Place Gasket (11) over neck of Glass (10)
6. Thread Glass (10) Into Holder (12).
Assembly
CAUTION: Read instructions
circuit breaker panel before beginning installation.
6
1
3
5
4
8
WIRE
WIRE
GROUND
& Installation
carefully and turn electricity off at main
PAGE 1 of 2
Instructions
12
11
9
5617
5697
10 5698
10 5511
5695
7191
7192
7193
SPEC.NO. 022214 10-24-08