Troubleshooting Guide; Ordering Parts - shark Navigator Lift-Away Professional UV541CCO Série Guide Du Propriétaire

TROUBLESHOOTING GUIDE

Vacuum is not picking up dirt�
• Check filters to see if they need cleaning� Follow instructions for rinsing and
drying the filters before re-inserting back into the vacuum� (See "Maintenance"
sections for instructions�)
• Dust cup may be full; empty dust cup�
• Check hose and hose connections for blockages; clear blockages if required�
• If dust cup is empty, and attachment inlets are clear, check for other blockages�
(See "Checking for Blockages" for instructions�)
Vacuum lifts scatter rugs (lightweight, movable rugs)�
•
Take care when vacuuming scatter-type rugs or rugs with delicately sewn edges� Open the
suction release on the handle to decrease suction power�
•
Move the On/Off switch to "I - Bare Floors" position to disengage the brush roll�
Airflow is restricted� No suction or light suction�
• Check filters to see if they need cleaning� Follow instructions for rinsing and
drying the filters before re-inserting back into the vacuum�
• Dust cup may be full; empty dust cup�
• Check hose, hose connections, nozzles and accessories for blockages; clear
blockages if required�
• Close the suction release on the handle to increase suction power�
• If dust cup is empty, and attachment inlets are clear, check for other blockages�
Brush roll does not spin�
• Immediately turn off and unplug vacuum, disconnect the nozzle and remove
blockage before reconnecting and turning vacuum back on�
• Pull the handle toward you and release the floor nozzle to disengage the
auto-off feature�
• Move the On/Off switch to the "II - Brush Roll On" position�
Vacuum turns off on its own�
This vacuum cleaner is equipped with a motor protective thermostat� If for some reason
your vacuum overheats, the thermostat will automatically turn the unit off� Should this occur,
perform the following steps to restart the motor thermostat:
1� Move the On/Off switch to the "O" (Off) position�
2� Unplug the vacuum�
3� Empty the dust cup and clean filters�
4� Check for blockages in hose, accessories and inlet openings�
5� Allow the unit to cool for a minimum of 45 minutes�
6� Plug in the vacuum�
7� Turn the On/Off switch to the "I" (On) position to restart the vacuum�
Note: If vacuum still does not start, contact Customer Service at: 1-800-798-7398�
16

Ordering Parts

1
2
3
4
5
6
To purchase replacement parts, please visit our website
sharkaccessories�com�
PART
1
Pre-Motor Filter Set
2 HEPA Filter
3 Dusting Brush
4 Crevice Tool
5 Pet Power Brush
6 Extension Wand
PART NO�
XFF350
XHF350
349FJV540
350FJV540
351FJV540
352FJV540
s h a r kc l e a n . c o m 17