Storage And Maintenance; Maintenance; Emptying The Dust Cup; Cleaning The Pre-Motor Filters - shark Navigator Lift-Away Professional UV541CCO Série Guide Du Propriétaire

STORAGE AND MAINTENANCE

Quick
Cord Release
Lower Cord
Storage Clip
STORE YOUR VACUUM SAFELY
1 Convert your vacuum back to upright
vac mode�
2 Rotate the upper quick cord release to its
upright position and coil the power cord
loosely around the two clips� Clip the plug
onto the cord to secure� (Fig� 17)
3 Store the dusting brush and the crevice
tool on the mounts on the accessory
holder�
12
Fig. 17
4 Store your vacuum cleaner safely in a cool
dry area where it will not be a hazard,
will not get damaged and will not cause
damage to anyone or anything�
NOTE: Empty dust cup after cleaning
and prior to storing� (See "Maintenance"
section for instructions�)

MAINTENANCE

COMPONENT MAINTENANCE SCHEDULE
1 Dust Cup Empty each time you vacuum�
2 Pre-Motor Foam Filter Rinse and air dry every 3 months under normal use�
3 Pre-Motor Felt Filter Rinse and air dry every 3 months under normal use�
4
Post-Motor HEPA Filter Clean once every 2 years or as needed�
Fig. 18
Screen
Filter
Fig. 20

EMPTYING THE DUST CUP

The dust cup needs to be emptied each time
you vacuum and periodically during cleaning,
when the dust cup appears full�
1 Undo the latches on the sides of the dust
cup by lifting them up and outwards to
remove the dust cup from the motor base�
(Fig� 18)
2 Hold the dust cup over a trash receptacle
and press the bottom door release button�
(Fig� 19) Tap gently to empty contents�
Press the door shut again until it clicks�
3 If needed, turn the dust cup upside down
over the trash receptacle and press the
top door release button� (Fig� 20) Tap
gently to remove contents�
Use a dry cloth or paper towel to remove
debris stuck to the screen filter inside the
dust cup� Press the door shut again until
it clicks�
IMPORTANT: Loss of suction
may occur if foam filters are not
cleaned every 3 months� Rinse
and allow to air dry completely�
Also, tap loose dirt off filter
between washes as needed�
Foam filters may appear dirty
after use - this is normal�
Pre-Motor
Foam Filter
Fig. 19
Felt Filter
Post Motor
HEPA Filter
Fig. 21
4 Replace the dust cup on top of the motor
base� Hook the two latches onto the tabs
on the sides of the dust cup and push
down to lock�

CLEANING THE PRE-MOTOR FILTERS

1
Remove the dust cup�
2 Pull the 2 filters out from the top of the
motor base� (Fig� 21)
3 Rinse the filters thoroughly in lukewarm
water until the water runs clear�
DO NOT put the filter in the washing
machine or dishwasher�
NOTE: The material in the filter will
discolor over time� This is NORMAL and
will not affect the performance of the filter�
4 Squeeze out excess water and let air-dry
for at least 24 hours before replacing�
Do not use a hair dryer or other heating
methods to dry�
5 Place the felt filter in first, then the foam filter�
6 Replace the dust cup�
s h a r kc l e a n . c o m 13