Playback; Digital Out - Lg Zenith Zda-710 Manuel D'installation

Troubleshooting
Symptom
No power. • The power cord is disconnected.
The power is on, but
•
the DVD player does
not work.
No picture.
•
• The video
No sound.
•
• The power of the equipment connected
•
The DVD player does •
not start playback.
•
•
The remote control
does not work properly.
• The
Specifications
General
Power requirements: AC 120V, 60 Hz
Power consumption: 8W
Dimensions (Approx.):
430 x 35 x 242 mm (17 x 1.4 x 9.5 inches)
(W x H x D) without foot
Weight (Approx.): 1.9 kg (4.2 lbs)
Operating temperature:
5 oc to 35 oc (41 OFto 95 OF)
Operating humidity: 5 % to 90 %
Outputs
VIDEO OUT:
1.0 (p-p), 75 Q, sync negative, RCA jack x 1
S-VIDEO OUT:
(Y) 1.0 V (p-p), 75 Q, negative sync, Mini DIN 4-pin x 1
(C) 0.3 V (p-p) 75 Q
COMPONENT VIDEO OUT:
(Y) 1.0 V (p-p), 75 Q,negative sync, RCAjackx
0.7 V (p-p), 75 Q, RCAjack x 2
Note: Design and specifications are subject to change prior notice.
PINO. : 3834RD0090E
Possible Cause
No disc is inserted.
The TV is not set to receive
signal output.
cable is not connected
securely.
The equipment connected with the
audio cable is not set to receive
signal output.
with the audio cable is turned
The AUDIO options are set to the
wrong position,
An unplayable disc is inserted.
The rating level is set,
The remote control is not pointed at
the remote sensor on the DVD player.
remote control is too far from
DVD player.
1
• Plug the power cord into the wall outlet
securely.
Insert a disc. (Check the disc indicator
•
in the display window is lit.)
DVD Select the appropriate video input
mode on the TV.
Connect the video cable securely.
•
Select the correct input mode of the
•
DVD audio receiver so you can listen to the
sound from the DVD player.
Turn on the equipment connected with
off. the audio cable.
Set the AUDIO option to the correct
•
position, then turn on the DVD player
again by pressing POWER.
Insert a playable disc. (Check the disc
•
type and regional code.)
Change the rating level,
•
Point the remote
•
sensor of the DVD player.
the Operate the remote control closer to
the DVD player.
AUDIO OUT:
2.0 Vrms (1 KHz, O dB), 600 Q, RCAjack (L, R) x 1
DIGITAL OUT (COAXIAL):
0.5 V (p-p), 75 Q, RCAjackx
System
Laser:
Semiconductor laser, wavelength 650 nm
Signal system: NTSC
Frequency response:
DVD (PCM 96 kHz): 8 Hz to 44 kHz
DVD (PCM 48 kHz): 8 Hz to 22 kHz
CD: 8 Hz to 20 kHz
Signal-to-noise ratio:
More than 90 dB (ANALOG OUT connectors only)
Harmonic distortion: Less than
Dynamic range:
More than 95 dB (DVD/CD)
Accessories:
Video cable (1), Audio cable (1), Remote control (1),
Batteries (2)
Correction
control at the remote
1
0.02%