Dolmar DUR368A Manuel D'instructions page 28

MAINTENANCE
WARNING:
Always be sure that the tool is
switched off and battery cartridge is removed
before attempting to perform inspection or main-
tenance on the tool. Failure to switch off and remove
the battery cartridge may result in serious personal
injury from accidental start-up.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Replacing the nylon cord
WARNING:
Use only the nylon cord with
diameter specified in this instruction manual.
Never use heavier line, metal wire, rope or the
like. Failure to do so may cause damage to the tool
and result in serious personal injury.
WARNING:
Always remove the nylon cutting
head from the tool when replacing the nylon cord.
WARNING:
Make sure that the cover of the
nylon cutting head is secured to the housing
properly as described below. Failure to properly
secure the cover may cause the nylon cutting head to
fly apart resulting in serious personal injury.
Replace the nylon cord if it is not fed any more. The
method of replacing the nylon cord varies depending on
the type of the nylon cutting head.
After replacing the nylon cord, pull both ends with your
TROUBLESHOOTING
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual,
do not attempt to dismantle the tool. Instead, ask Makita Authorized Service Centers, always using Makita replace-
ment parts for repairs.
State of abnormality
Motor does not run.
Motor stops running after a little use.
It does not reach maximum RPM.
Probable cause (malfunction)
Battery cartridge is not installed.
Battery problem (under voltage)
The drive system does not work
correctly.
Battery's charge level is low.
Overheating.
Battery is installed improperly.
Battery power is dropping.
The drive system does not work
correctly.
28 ENGLISH
hands to remove any slack and adjust it to the specified
length.
95-M10L
► Fig.41
96-M10L
► Fig.42
98-M10L
► Fig.43
B&F ECO 4L
► Fig.44
For Ultra Auto 4
► Fig.45
UN-74L
► Fig.46
Manual feed type
When the nylon cord gets short, pull it out from the
eyelet and feed it from the another eyelet.
► Fig.47
Replacing the plastic blade
Replace the blade if it is worn out or broken.
► Fig.48
When installing the plastic blade, align the direction of
the arrow on the blade with that of the protector.
► Fig.49: 1. Arrow on the protector 2. Arrow on the
blade
Remedy
Install the battery cartridge.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Recharge the battery. If recharging is not effective,
replace battery.
Stop using of tool to allow it to cool down.
Install the battery cartridge as described in this
manual.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.