Motion Detection; Set Serial; System; Time Set - urmet domus DS1093 Manuel Utilisateur

4.2.13

MOTION DETECTION

Click [MainDeviceMotion] to enter into the [Motion Detection] menu. The [Motion detection] Menu has three sections,
including Channel Status, Sensitivity and Motion area.
4.2.14

SET SERIAL

(only for 1093/016 DVR Model)
4.2.15

SYSTEM

4.2.16

TIME SET

DS1093-038
 Channel STATUS: This option allow you enable motion detection on any channel.
 SENSITIVITY: This option allows you to set sensitivity level of motion detection from 1 to
4 with 4 being the most sensitive.
 MD AREA: This option allows you select the area you want to be sensitive to motion.
The channel is separated into a 13X10 area. When any object moves into the motion
detection area, and the area where the object is located is displayed in red recording will
be triggered. In the semi-transparent area the motion detection is off.
When Multiple DVRs are controlled by keyboard, user needs to set communication
protocol.
 Baud rate: set baud rate of serial protocol
 Data Bit: Set data bit.
 Stop Bit: Set stop bit
 Check: allow you set [Check] to none.
The [System] Menu includes the below sub-menus: Time Set, User Password,
Audio/Video Setting, Language select, System Info and System Maintain.
After entering into the [System] menu, you can freely configure the system parameters
to meet your needs.
On the [System] menu screen, click [Time] icon to enter into [Time set] menu.
Now you are allowed to modify system date, time, date/time format and time zone,
setup DST (day saving time) status and mode.
94