Resistance Measurement - Ht Instruments Ht3010 Manuel D'utilisation

5.4. RESISTANCE MEASUREMENT

Before attempting any resistance measurement, remove power from the
circuit under test and discharge all capacitors, if present.
Fig. 6: Use of the instrument for Resistance measurement
1. Select the position 
2. Insert the red cable into input terminal VHz
terminal COM.
3. Position the test leads in the desired points of the circuit to be measured (see Fig. 6).
The display shows the value of resistance.
4. If the symbol "O.L" is displayed, this indicates overload status.
5. For use the HOLD, RANGE and MAX MIN functions, please refer to § 4.2.
CAUTION
and the black cable into input
EN – 11
HT3010