Use Of These Operating Instructions; Display And Error Messages - Bellini SUPERCOOK Manuel D'utilisation

Use of these operating
instructions
This symbol indicates warnings which you must read before use:

Display and error messages

Symbol / Question /
Description of error
The kitchen machine stops
when the whisk paddle is used.
The speed is irregular or the
motor is sticking.
The knife is working very slowly
when preparing dough.
There is smoke coming from
the kitchen machine.
Kitchen machine not working
with the temperature set and
speed set over 5.
Jar is difficult to fit.
Is the kitchen machine used?
The jar base shows marks and
residual moisture on delivery.
Noises when first used or
under heavy load.
Beeping noise.
4
Explanation
The jar is not sealed correctly or the safety switch is not working.
The kitchen machine has an error in the electrical circuit.
The motor is overloaded.
The kitchen machine has a special control system. The speed can vary
and the rotation is interrupted in 2-second intervals. This means that the
kitchen machine starts making an unusual noise. This is normal. This
noise means that the speed of the knife is being adjusted to prevent the
motor overheating.
Please check whether you have exceeded the maximum of 500 g of flour.
The motor is overheating. Check the maximum fill level.
The temperature can only be set for speeds 1 to 4.
Positioning the jar gets easier with use, as the silicon seal alters as a
function of the heat and humidity, while still forming a seal.
All kitchen machine modules are tested prior to delivery. The jar is filled
with water and brought to the boil. As with a dishwasher, residual moisture
can be left behind. These residues can result in slight but perfectly safe
marks on the base of the jar.
When first used and under heavy load, the motor can heat up and make
strange noises. As in any electric motor, e.g. in a model railway or model
motorway, the engine uses brushes needs to be ‚run in' to begin with. The
noises are nothing to be concerned about.
The module beeps to tell you the kitchen machine has reached the right
temperature.
Solution
Please check the seal again.
Please contact 1300 373 199 for
directions.
Please switch the kitchen machine off
and wait a few minutes until the motor
has cooled down.
Remove part of the mixture or increase
the speed to a maximum of 3.
Increase the speed from 1 to 2 or from
2 to 3.
Remove some of the mixture from the jar.
Remove some of the mixture from the jar.
Allow the kitchen machine to cool down
for around 20 minutes.
Change the speed setting to 1 to 4.
Rub a little cooking oil into the silicon seal
or moisten it.
In order to remove the marks, please use
a conventional stainless cleaner, such as
Sidol from Henkel.
Allow the kitchen machine to cool
down after it has been working hard,
e.g. kneading firm dough. The kitchen
machine will be fully operational again
after cooling down.
The beeping also indicates that the
pre-set time has run out.