Whirlpool WHKF-DWH Guide D'installation, D'utilisation Et D'entretien page 4

5. When installing on metallic plumbing: Securely install two
grounding clamps and a #4 copper wire across the location
where the system will be installed, tightly clamping it at both
Ground clamp
6. Cut pipe to length with pipe cutter.
7.
"IN" port with red air release button is connected to incoming
water supply line. Tighten compression nuts on both sides of
valves (see Figure 4). (Four locations.)
Incoming
water
supply
compression
8. Lubricate housing o-ring with water.
9.
properly.
10. Slowly turn main water supply on while depressing red air
• 4 • English
Ground wire
air release button
In
Tighten
nuts
Ground clamp
Red
Out
Tighten
compression
nuts
Figure 3
Outging
water
Figure 4