Whirlpool WHKF-DWH Guide D'installation, D'utilisation Et D'entretien page 2

Assembly schematic
is based on suggested
materials.
NOTE: Assembly of this
adapters. Fittings can
be either sweated or
threaded.
Parts and Materials Included
A. Filter Head
B. Housing
C. Housing Wrench
Tools & Parts Needed
Gather the required tools before starting installation. Read and
follow the instructions provided with any tools listed here.
• Two 3/4" male x 3/4" street adapters
• Two 3/4" gate valve (compression type)
• Plumbers tape
• Adjustable Wrench
• Pipe Cutter
• Filter
• When installing on metallic plumbing: two grounding clamps and
#4 copper wire.
Installation Requirements
•
•
may result from excessive heat and void warranty.
• Filter housing is intended for use on cold water line.
• Install in a location that is not susceptible to freezing temperatures
as damage to the housing could occur.
• Install away from direct sunlight as prolonged exposure to light
can weaken plastic components.
•
change.
• Some local codes may require the use of a licensed plumber or
and follow any and all local codes and requirements.
•
hangers or optional Whirlpool Bracket WHKF-B6.
• 2 • English
A
B
C