Installation Location; Room Temperature, Ventilation And Cavity Depth; Ambient Temperature - Blaupunkt 5CT2 Série Mode D'emploi

Installation location

Install the appliance in a dry, well
ventilated room. The installation location
should neither be exposed to direct
sunlight nor near a heat source, e. g.
a cooker, radiator, etc. If installation next
to a heat source is unavoidable, use
a suitable insulating plate or observe
the following minimum distances to a
heat source:
3 cm to electric or gas cookers.
■
30 cm to an oil or coal-fired cooker.
■
Room temperature,
ventilation and cavity
depth

Ambient temperature

The appliance is designed for a specific
climate class. Depending on the climate
class, the appliance can be operated at
the following temperatures.
The climate class can be found on
the rating plate. Fig. (
Climate class
SN
N
ST
T
Note
The appliance is fully functional within
the room temperature limits of the
indicated climatic class. If an appliance
of climatic class SN is operated at colder
room temperatures, the appliance will
not be damaged up to a temperature
of +5 °C.
Permitted ambient
temperature
+10 °C to 32 °C
+16 °C to 32 °C
+16 °C to 38 °C
+16 °C to 43 °C
Room temperature switch
If the room temperature drops
below 16 °C, the freezer compartment
of appliances belonging to climatic
class SN may become too warm.
In an extreme case the frozen food may
thaw. To prevent this from happening,
switch on the room temperature switch.
As a result, the refrigerating unit
operates more frequently. The appliance
can now be operated at a room
temperature of +10 °C to +16 °C.
To switch on, press the room
temperature switch, Fig. "/B. Mark "0"
is no longer visible. The light inside
the appliance is lit at a reduced
luminosity.
To save energy, switch off the room
temperature switch as soon as the room
temperature exceeds +16 °C.
Ventilation
The air on the rear panel of the appliance
heats up. Conduction of the heated air
must not be obstructed. Otherwise, the
refrigeration unit must work harder. This
increases power consumption.
Therefore: Never cover or block the
ventilation openings!
Cavity depth
A cavity depth of 560 mm is
recommended for the appliance. If the
cavity depth is smaller – at least
550 mm – the energy consumption
increases slightly.
en
23