Operation; Switching On/Off; Working Instructions; Regular Cuts - Parkside 479237 2410 Mode D'emploi

1. Turn the quick-release chuck
in the direction of the arrow until it
stops. Hold the quick-release chuck
in this position.
2. Push the saw blade
quick-release chuck
3. Release the quick-release chuck
so that it returns to its initial position.
4. The saw blade
˜ Operation
˜ Switching on o
CAUTION! Risk of injury!
m
Always wear protective gloves
when handling or working with
the product.
CAUTION! Risk of injury!
m
Before switching on the product:
u
Ensure the saw blade
contact with the workpiece.
Ensure your stance is stable.
u
Always hold the product firmly with
both hands while working.
Keep your hands away from the
u
saw blade when the product is
1 ] [
in operation.
NOTE
ou cannot lock the on/off
u
switch for continuous operation.
[ ]
Switching on
1. Release the switch lock
pushing it in on the left or right side.
2. Press and hold the on/off switch
3. Regulate the speed as required by
changing the amount of pressure on
the on/off switch
Switching o
1. Release the on/off switch
2. hen releasing the on/off switch
the switch lock
its original position.
36 GB/IE
3 ] [
into the
1 ] [
until it stops.
3 ] [
[ 3 ]
is now locked.
[ 1 ]
is not in
[ 1 ]
by
6 ] [
[
.
[ ]
.
[ ]
[
moves back into
[ 6 ]
˜ Working instructions
CAUTION! Risk of injury and
m
damage to property!
Wear protective gloves when
u
handling the saw blade
way, you avoid injury from cuts.
Do not use any blunt or bent saw
u
blades or saw blades which are
damaged in any other way.
Before sawing the workpiece,
u
check for hidden foreign objects
such as nails and screws and
remove them.
Always insert a suitable saw blade.
u
Secure the workpiece with the
u
aid of clamping devices on the
workbench.
Apply only as much pressure as
u
is required for sawing. If there is
excessive pressure, the saw blade
may bend and break.
Switch the product off immediately
u
if the saw blade jams. Try to spread
the saw cut and carefully pull the
saw blade out.
Always stand to the side of the
u
product when working.
Always make sure that the
u
workplace is well ventilated.
Avoid over-stressing the product
u
while working.
Saw the material at a constant
u
speed.
.
]
˜ Regular cuts
1. erify the saw blade
touching the workpiece.
2. Switch the product on.
3. Apply the base plate
workpiece.
,
]
4. Use even pressure, advancing at a
steady pace when making the cut.
. In this
1 ] [
is not
1 ] [
to the
2 ] [