Publicité
4. Start the engine, read the voltage after cranking the starter.
FOR CHARGING SYSTEM TEST
1. After starter test, press "ENTER" button to go to charging system
2. Run up the engine to 1200 ~ 1500 rpm, read the voltage while the
3. Following when the charging system is idle, continue the charging
FOR RIPPLE TEST
1. After charging system test, press "ENTER" button to go ripple test,
[Texte]
A. : Starting system ok.
OK
B. : Starting system weak. Check connections, wiring, and
LO
starter.
C. ---v : Starting system problem. Check connections, wiring, and
starter immediately.
test, the screen shows
��.��v.
car is running.
A.
: Charging system ok.
OK
B.
: Charging voltage is too high, check regulator.
HI
C.
: Charging voltage is too low, check connections, wiring and
LO
alternator.
system test with accessory loads. Turn on the blower to high (heat),
high beam headlights, and rear defogger. Do not use cyclical loads
such as air conditioning or windshield wipers.
A.
: Charging system ok.
OK
B.
: Charging voltage is too high, check regulator.
HI
C.
: Charging voltage is too low, check connections, wiring and
LO
alternator.
LCD shows
RIPPLE
to read live voltage, LCD shows
ALT.
and get the reading of ripple voltage
Publicité
