Publicité
RECHARGE
RETEST
BAD
ERROR
13. Press <<ENTER>> return to Step 3 or remove the test clamps from
the battery posts after completion of testing.
14. All selected data will be memorized after test, including battery
type, battery CCA standard, capacity of CCA, etc.
SYSTEM TEST- 12V
FOR STARTER SYSTEM TEST
1. LCD display will light on and show the voltage of the battery
��.��v o n
CRANKING
NOTE : If you see / / blank / RIPPLE appeared on the
screen or flickers, please refer to TROUBLESHOOITING.
2. Turn off all vehicle accessory loads such as light, air conditioning,
radio, etc. before starting the engine.
3. Press "ENTER" button. LCD shows
[Texte]
Battery is discharged. The battery condition cannot
be determined until it is fully charged. Recharge &
re-test the battery. If reading is the same, the battery
should be replaced immediately.
- The battery can not hold a charge. It should be
replaced immediately. Or
- The battery has at least one cell short circuit. It
should be replaced immediately.
- The clamps are not connected properly. Please
check if the clamps are connected properly. Or
- The tested battery is bigger than maximum testing
CCA capacity.
the screen. Please press ϧ \ ϰ key to select
for system test. Press "ENTER" to the next step.
HI L
O
.
Publicité
