Publicité
7. Press "ENTER" to the next step.
8. Please press ϧ\ϰ key to input the battery capacity of CCA or
9. Test the battery within 1 second.
10. If the display shows BAT. & XX.XXv, please recharge the battery
11. If the display shows
12. When the test is complete, the LCD shows the actual voltage and
[Texte]
CA(MCA)Κ
SAE : 40~1200 CCAΘDIN : 20~670 CCAΘIEC : 25~790 CCAΘ
EN : 35~1125 CCAΘCA(MCA) : 70~1440 CA(MCA)
Press "ENTER" to begin the test.
then re-test. If reading is the same, the battery should be replaced
immediately.
please press ϧ\ ϰ key to answer
"ENTER" to the next step. DBT300 tester will judge
the tested battery status & decide to show out Step11.)
actual CCA. Press the ϧ\ϰ key to see the SOC (STATE OF
CHARGE) , SOH (STATE OF HEALTH) or m� (Internal
Resistance).
HI or LO m�
One of following five results will be displayed:
The battery is good & capable of holding a charge.
OK
OK
The battery is good but needs to be charged.
RECHARGE
BAT.CHARGED
means it is out of range.
(Is tested battery charged?),
or
NO
then press
YES
Publicité
