Publicité
MULTIPLEX Modellsport GmbH & Co.KG
Westliche Gewerbestraße 1
D-75015 Bretten-Gölshausen, Germany
www.multiplex-rc.de
Why WINGSTABI EASY Control?
This software runs on all WINGSTABI and, in contrast to the previous WINGSTABI,
does not require a PC for setup. Consequently, WINGSTABI EASY Control can be
integrated in every model programmed on your transmitter and, after a short
teach-in procedure (which servo does what), be flown.
In the factory default setting, the gyro function is switched off in the EASY Con-
trol software so that a model containing WINGSTABI EASY Control can be pro-
grammed on the respective transmitter - as would normally be the case without
a gyro. Thanks to automatic RC system recognition, almost all RC equipment
with a serial signal output at the receiver (Multiplex SRXL, HiTEC SL, Jeti EXBUS,
Futaba S.BUS, Graupner HOTT, JR XBUS Mode B, PPM) is suitable. WINGSTABI
with integrated receiver is the best solution for M-LINK users.
If the smaller scope of system-related functions provided by EASY Control is
insufficient, simply modify the software setting options on a computer (Windows
PC/notebook) as desired using the MULTIPLEX Launcher via the USB interface.
Alternatively, it is also possible to switch to the "CLASSIC" software version,
which offers a much wider range of functions. The MULTIPLEX Launcher and
the two WINGSTABI software versions are available free of charge along with
possible updates.
EASY Control
Setting up WINGSTABI EASY Control without a PC
In principle, WINGSTABI EASY Control can be used in every installation position,
but the standard installation position is, however, required for setup without a
PC: "Laying flat", with the servo connections facing the rear. Other positions can
only be selected using the MULTIPLEX Launcher.
The teach-in procedure commences when WINGSTABI EASY Control is started
with inserted jumper at the MSB connection.
IMPORTANT NOTE: All the mixers must be switched off for the teach-in
procedure. This applies, in particular, to elevator mixing, Combi-Switch
as well as Snap-Flap. Dual-Rate should also be switched off. All the
controllers (trims) at the transmitter must be set to NEUTRAL.
After switching on the transmitter (must be connected to the receiver), eight
teach-in steps are carried out. The model stands on the ground, only the sticks
of the transmitter will be moved. The current step is indicated by the operation
LED flashing green. The number of flashes corresponds to the respective step.
Fast flashing indicates that a step has been completed: green = ok, red =error.
The teach-in procedure informs WINGSTABI EASY Control which servo is oper-
ating which function and which maximum distance it can travel. This results in
special features for V-tail and Delta airplane models.
Publicité
