Symbols On The Product - Husqvarna DMS 240 Manuel D'utilisation

Product overview - drill stand
1. Jack screw
2. Drill column
3. Scale for depth and angle
4. Angle indicator
5. Drill motor carriage
6. Screw that locks the angle of the drill column
7. Handle
8. Feed lever
9. Rear support
10. Installation plate
11. Lock for drill motor carriage
12. Gearbox
13. Gear rack
14. Wheel set that can be removed
4
6
7
8
9
14
2
3
12
13
16
15. Level adjustment screws
16. Bottom plate
17. Hex key, 3 mm and 4 mm
18. Operator's manual

Symbols on the product

WARNING: Be careful and use the product
correctly. This product can cause serious
injury or death to the operator or others.
Read the manual carefully and make sure
that you understand the instructions before
you use the product.
1
4
5
10
11
15
17
18
898 - 002 - 20.06.2019