Makita DUR365U Manuel D'instructions page 9

To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided.
To start the tool, grasp the right grip (the lock-off lever is
released by the grasp) and then pull the switch trigger.
To stop the tool, release the switch trigger.
NOTE:
• The tool is automatically turned off after the tool
is left one minute without any operations.
Speed adjusting
2
1
► 1. Main power button 2. Speed indicator
You can adjust the tool speed by tapping the main
power button.
Each time you tap the main power button, one of the
speed indicator lights up in order of Turtle(
Rabbit( ).
is for low speed and
middle indicator for middle speed.
Reverse button for debris removal
WARNING:
• Switch off the tool and remove the battery
cartridge before you remove entangled
weeds or debris which the reverse rotation
function can not remove. Failure to switch off
and remove the battery cartridge may result in
serious personal injury from accidental start-up.
► 1. Reverse button
This tool has a reverse button to change the direction of
rotation. It is only for removing weeds and debris entan-
gled in the tool.
), middle,
for high speed , and the
1
To reverse the rotation, tap the reverse button and pull
the trigger when the tool's head is stopped. The power
lamp starts blinking, and the tool's head rotates in
reverse direction when you pull the switch trigger.
To return to regular rotation, release the trigger and wait
until the tool's head stops.
NOTE:
• During the reverse rotation, the tool operates
only for a short period of time and then automat-
ically stops.
• Once the tool is stopped, the rotation returns to
regular direction when you start the tool again.
• If you tap the reverse button while the tool's
head is still rotating, the tool comes to stop and
to be ready for reverse rotation.
Nylon cutting head (optional
accessory)
NOTICE:
• The bump feed will not operate properly if the
head is not rotating.
► 1. Most effective cutting area
The nylon cutting head is a dual string trimmer head
provided with a bump & feed mechanism.
To cause the nylon cord to feed out, the cutting head
should be bumped against the ground while rotating.
NOTE: If the nylon cord does not feed out while
bumping the head, rewind/replace the nylon cord
by following the procedures described under
"Maintenance".
ASSEMBLY
WARNING:
Always be sure that the tool is switched
•
off and battery cartridge is removed before
carrying out any work on the tool. Failure to
switch off and remove the battery cartridge may
result in serious personal injury from accidental
start-up.
• Never start the tool unless it is completely
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.
9 ENGLISH
1