Haier HW80-BP14357TU1 Notice D'utilisation page 64

Problem
Excessive foam fl-
oats drum and/or
detergent drawer.
Automatic ad」ust­
ment of wash
time.
Spinning fails.
Unsatisfactory
wash ng result.
i
Wash ng powder
i
res dues are on the
i
laundry.
Laundry has grey
patches.
[IJ
No e: Foam
t
If too much foam is inspected during spin c
tivated for 90 seconds. If that elimination of foam fails up to 3 times, programme ends
without spinning.
Should the error messages reappear even after the taken measures, switch off the appli­
ance, disconnect the power suppl
10.4 lncaseo
The current programme and its setting will be saved.
When power suppl
sumed.
If a power failure cuts an operating wash programme
door opening is mechanicall
y
laundr water level should not be seen in the glass
porthole of the door. - Danger of burns! Water level
has to be lowered as described in "Pump filter". Not till
then pull lever (A) beneath service flap (Fig.10-1) until
door s unlocked b
i
p
arts.
U
When thewashmgmachmema safestate(under thewater |eve|be|owthewmdow a|onga certam
distance, barrel temperature below SS
J.
machine operation.
I
28
Cause
• Detergent is not a appropriate.
• Excessive use of detergent.
• Washing programme duration will • T his is normal and doesn't af-
ng be ad」usted.
i
• Unbalance of laundry
• Degree of pollution does not agree
with selected programme
• Detergent quantitiy was not suf­
什c ent.
i
• Max
mum load has been exceeded.
i
• Laundry was unevenly d
n the drum.
i
• Insoluble particles of detergent can • Perform extra rinse.
r � main as white spots on the laun- . Try to brush the points from the
dry.
• Caused by fats such as oils, creams • Pretreat the laundry with a spe-
or o ntments.
i
rma
fo ti
fp fa
ower ilure
y
is restored operation will be re­
y
blocked. To get out an
y g
a entle cl ck. Afterwards refix all
i
str buted
i i
on
y
cle, motor stops and drain pump will be ac­
y
and contact the customer service.
C, the inner barrel did not turn), may unlock the doors of the
0
Solution
• Check detergent recommen­
dations.
• Reduce amount of detergent.
feet functionality.
• Check mach
ne load and laun­
i
dry and run a spinning program­
me aga n.
i
• Select an other programme.
• Choose the detergent acc.
to the degree of pollution and
accord ng to manufacture
i
speci什cations
• Reduce load ng.
i
• Loose the laundry.
dry laundry.
• Choose an other detergent.
c al cleaner.
i
10-1
|
y
y
EN
A