FAR RT1325X Manuel D'instructions page 39

• To ensure proper ventilation for your refrigerator, allow for a
200mm space on each side between walls, a 100mm space
between the back of your refrigerator and the wall, and a 300mm
space between the countertop and the roof or ceiling.
• If you are installing your refrigerator next to a fixed wall, leave suffi-
cient space on the hinge side to allow for the door to swing open.
• Never install your refrigerator near a heat source or in direct
sunlight.
ELECTRICAL REQUIREMENT
WARNING: DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTOR.
DO NOT USE EXTENSION CORD.
Failure to follow these instructions can result in death, fire or electri-
cal shock. Before you move your refrigerator into its final location, it
is important to make sure you have the proper electrical connection.
RECOMMENDED EARTHING METHOD
A 220~240 Volt / 50-60 Hz AC only 10 ampere fused and properly
earthed electrical supply is required. It is recommended that a sepa-
rate circuit serving only this appliance be provided. Use a receptacle
which cannot be turned off with a switch or pull chain. Do not use an
extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, turn the refrigerator control to OFF and then
disconnect the refrigerator from the electrical source. When
finished, connect the refrigerator to the electrical source and reset
the control to the desired setting.
LEVELING
If the refrigerator is not leveled during installation. The doors may
not close or seal properly, causing cooling, frost, or moisture prob-
lems. It is very important of the refrigerator to be level in order to
EN-36
ENGLISH