Installing Your Refrigerator - Far Rt1325X Manuel D'instructions

ENGLISH

INSTALLING YOUR REFRIGERATOR

The user should take out the door handle in the plastic bag, and
install it onto the door. Then take out the two handle stopper and
cover the installed screws with them. The handle stopper and screw
stopper in the plastic bag can be used when the user wants the door
to be opened from left.
UNPACKING YOUR REFRIGERATOR
WARNING: Two or more people are required to move the refrigera-
tor.
• Remove all the tapes and labels from your refrigerator before use
(except the rating label).
To remove any remaining tape or glue, rub the area briskly with your
thumb.
Tape or glue residue can also be easily removed by rubbing a small
amount of liquid dish soap over the adhesive with your fingers. Wipe
with warm water and dry.
• Do not use sharp instruments, rubbing alcohol, flammable fluids, or
abrasive cleaners to remove tape or glue. These products can
damage the surface of your refrigerator.
• When moving the refrigerator, do not tilt the refrigerator beyond
45° from the upright position.
CLEANING BEFORE USE
After you remove all of the packaging materials, (in particular, the
foam between the outside condenser and compartment should be
taken off) clean the inside of your refrigerator before using it.
SPACE REQUIREMENTS
WARNING: Keep flammable materials such as petrol and vapours
away from the refrigerator. Failure to do so may result in death,
explosion, poisoning or burns.
EN-35