Télécharger Imprimer la page

Barbecook KADUVA INOX Mode D'emploi page 31

Publicité

Yellow flames
Impossible to light burner with igniter
Flames jumping out of the burner box
Excessive heat and flare-ups
Flames behind control panel
Regulator humming
Incomplete flame
Warming rack does not fit
TROUBLESHOOTING GUIDE FOR ELECTRIC IGNITION
Problem
No sparks when pressing the ignition;
no sound
No sparks when pressing the ignition;
sound is present
Sparks are present but not with all elec-
trodes and/or not powerful enough
HANDBUCH FÜR MONTAGE,
BETRIEB UND WARTUNG
• Venturi tubes are partly blocked
• Salt on burner
• The product is connected to Buthane.
• Ignition wire not fitted properly
• Defective ignition electrode
• Faulty ground
• Defective igniter
• Windy weather
• Cylinder almost empty
• Too fatty food
• Blocked fat drain hole
• Cooking system not positioned correclty
• Blocked venturi tubes
• Temporary situation caused by high outside temperature or
full cylinder
• Plugged, leaky or rusted burner
• Legs are angled too narrowly, or too widely
Probable cause
• Battery not installed correctly
• Empty battery
• Ignition button not installed correctly
• Defective spark generator
• Faulty ground
• Faulty ground
• Spark flashover away from burner(s)
• Low battery
• Electrodes are wet
• Electrodes cracked or brokenn "sparks are present"
-
-
• Clean venturi tubes
• Clean burner
• Connect the product to Propane with the right connector.
• Check all connections
• Check installation of electrodes, burner and igniter
• Replace igniter
• Move barbecue with rear side pointing towards the wind
• New cylinder or fill up
• Trim excess fat or reduce heat
• Clean bottom of burner box and burner
• Position cooking system correctly
• Shut off gas immediately, allow barbecue to cool down and
clean venturi tubes
• This is not a defect or a hazard
• Clean / replace burner
• The warming rack feet are adjustable. Bend them to fit into
the warming rack holes.
Solution
• Install battery (ensure that Ò+Ó and Ò-Ó are oriented cor-
rectly, with Ò+Ó at the top and Ò-Ó at the bottom)
• Replace with new AA battery
• Screw off button and reinstall
• Replace spark generator
• Remove and reconnect all connections with spark generator
and electrodes
• Remove and reconnect all connections to the spark genera-
tor and the electrodes
• If sparks are present that do not originate from the
burner(s), the wiring may be damaged. Replace the wiring.
• Replace with new AA battery
• Use paper tissues to remove the dirt
• Replace cracked or defective electrodes
-
-
-
-
-
-
-
www.barbecook.com
-
-
-
-
-
31

Publicité

loading