Free Hand According To The Scribe Mark; Plunge Cutting Without Pilot Drilling; Accessories, Tools; Festool Guide System Fs - Festool TRION PS 300 EQ Guide D'utilisation

11.1
12
13.2
14.1
14.2
13.1
14.3
9
• Clean tool regularly of dust accumulations in the
motor housing.
• Wear protective goggles.
Free hand accord-
ing to the scribe mark
The point at the leading edge of the splinterguard
[11.1] points to the blade cut line, making it easier
to cut to a scribe mark.

Plunge cutting without pilot drilling

The base runner must be in the front position for
plunge cuts in wood materials (basic setting).
Place the saw on the front edge of the runner. Set
saw to maximum stroke rate and pendulum stroke
setting 3, and start the plunge cut into the work-
piece [illustration 12].

Accessories, tools

For safety reasons, only use original
Festool accessories and tools!
Festool offers sawblades which are ideally matched
to your Festool jigsaw and application, to ensure
quick and clean cuts in a variety of materials.
The accessory and tool order number can be found
in the Festool catalogue or on the Internet under
www.festoolusa.com.

Festool guide system FS

The use of the Festool guide system FS facilitates
the production of straight and precise cuts, particu-
larly with material thicknesses up to 20 mm (1/4").
To do this, the jigsaw is placed in a guide stop [13.1]
(490031) and guided along the guide rail.
The guide stop has two adjustable limit stops [13.2]
for a setting free from play.

Parallel guide

Use the parallel guide (486719) to guide the jigsaw
parallel to the workpiece edge.
The parallel guide can be fi tted on both sides of the
base runner:
- Turn off and unplug tool.
- Slide clamping clip [14.2] onto the base runner
from the front.
- Insert parallel guide [14.3] through the clamping
clip from the side to the desired position.
- Tighten rotary knob [14.1].