Bluetooth - Yamaha NX-B150 Mode D'emploi

■ Bluetooth

Problem
Cannot make this unit A pairing operation was not done within about 5 minutes
pair with the connection
after pressing and holding
device, or cannot
The connection device does not support A2DP.
establish a connection.
There is a device (microwave oven, wireless LAN, etc.) that
outputs signals in the 2.4 GHz frequency band nearby.
Another device is already connected to this unit.
The pairing information is stored on the connection device
but has been deleted from this unit.
The
This unit has not been registered to the
on the connection device.
No sound is produced or The
the sound is interrupted device has been disabled.
during playback.
There is a device (microwave oven, wireless LAN, etc.) that
outputs signals in the 2.4 GHz frequency band nearby.
This unit is not set as an output destination on the
connection device.
Cause
( ).
function is disabled on the connection device. Enable the
connection of this unit and the connection
Perform the pairing operation within about 5 minutes on the
connection device. (☞ page 10)
Pair with a device that supports A2DP.
Place this unit apart from such devices.
Disable the current
Delete the pairing information on the connection device,
and then pair with this unit again. (☞ page 10)
device list Perform the pairing operation again. (☞ page 10)
Reestablish a
Place this unit apart from such devices.
Set this unit as an output destination on the connection
device.
Troubleshooting
Solution
connection. (☞ page 11)
function on the connection device.
connection. (☞ page 11)
13
En