Power Supply - IMG STAGELINE ATS-10R Mode D'emploi

4 Power Supply

The receiver is supplied with power via the
two supplied rechargeable NiMH batteries.
For fast and convenient charging of the bat-
teries, the charging station ATS-10PS from
the "img Stage Line" range is available as an
accessory.
Instead of the rechargeable batteries it is
also possible to use two non-rechargeable
1.5 V batteries of size AA.
1) Slightly press the grooves on the battery
compartment cover (11) while pulling the
cover downwards at the same time.
2) Insert the (rechargeable) batteries with
the positive and negative connections as
printed in the compartment.
3) Replace the cover and let it lock into place.
5 Operation
1) Screw the supplied antenna (1) into the
threaded jack ANT. (5).
2) The sound can be reproduced via the inte-
grated speaker (4) or via the supplied ear-
phone. When using the earphone, con-
nect it to the jack EAR. (6) [the speaker is
switched off in this case] and attach the
earphone to your ear.
3) Use a narrow object (e. g. screwdriver) to
set the channel selector switch CHANNEL
SELECT (9) to the same position as the
channel selector switch on the transmitter.
4) Use the clip (10) to fasten the receiver to
your clothes, e. g. belt.
5) Switch on the transmitter.
6) To switch on the receiver, set the sliding
switch (7) to the left stop to ON. (In the
mid-position STAND BY, the receiver is
also switched on but it is mute, i. e. no
sound is reproduced via the speaker or
earphone.)
All rights reserved by MONACOR
manual may be reproduced in any form or by any means for any commercial use.
After switching on, the LED BATT. LOW
(8) shortly flashes red before permanently
showing green. (If the LED shows a
dim green light only, no radio signal is
received, i. e. the transmitter is switched
off or set to a different channel than the
receiver.) If the LED permanently shows
red, the (rechargeable) batteries are al-
most exhausted and must be recharged
or replaced.
7) After the volume for the audio signal has
been adjusted on the transmitter, adjust
the desired reproduction volume with the
control VOL (2).
8) To switch off the receiver, set the sliding
switch (7) to the right stop to OFF: The
LED BATT. LOW (8) shortly flashes red
before it is extinguished.
9) In case of problems caused by interfer-
ence or poor reception see the corre-
sponding notes in the instruction manual
of the transmitter.
6 Specifications
Type of unit: . . . . . . . . 16-channel PLL
Radio frequency
range: . . . . . . . . . . . . 863 – 865 MHz
Ambient temperature: 0 – 40 °C
Power supply: . . . . . . via the two supplied
Dimensions: . . . . . . . 92 x 65 x 25 mm
Weight: . . . . . . . . . . . 80 g (without re-
Subject to technical modification.
® INTERNATIONAL GmbH & Co. KG. No part of this instruction
receiver for wireless
audio transmission
1.2 V rechargeable
NiMH batteries or via
two 1.5 V batteries of
size AA
chargeable batteries)
GB
7